• There seems to be an uptick in Political comments in recent months. Those of us who are long time members of the site know that Political and Religious content has been banned for years. Nothing has changed. Please leave all political and religious comments out of the forums.

    If you recently joined the forums you were not presented with this restriction in the terms of service. This was due to a conversion error when we went from vBulletin to Xenforo. We have updated our terms of service to reflect these corrections.

    Please note any post refering to a politician will be considered political even if it is intended to be humor. Our experience is these topics have a way of dividing the forums and causing deep resentment among members. It is a poison to the community. We appreciate compliance with the rules.

    The Staff of SOH

  • Server side Maintenance is done. We still have an update to the forum software to run but that one will have to wait for a better time.

C-47_USN_Port_Lyautey.zip

gman5250

gman5250

Charter Member
181215776375462265.jpg

A new entry has been added to Add-Ons Library, category P3D / P4D Add-Ons - General Military repaints

Description: This folder contains a P3Dv4.5 PBR repaint for the Douglas C-47 by Manfred Jahn and team in the scheme of Douglas C-47 USN_Port_Lyautey

50792. United States Navy Douglas R4D-6 Skytrain - Aircraft 15133 was built as a C-47B-15-DK and taken on strength by the USAAF as 43-49317. It was later transferred to the Navy as rendered here. On retirement from military service it became N2893F and finally 7O-ACB with Alyemda around 1977.

Rivet and bump detail by Ted (Tufun) Wolfgang.

To check it out, rate it or add comments, visit C-47_USN_Port_Lyautey.zip
The comments you make there will appear in the posts below.
 
Sure wish the rivet detail would apply to the model that doesn't have rebecca (Yagi) antenna. That antenna was a WWII system used for guiding bombs and para drops.

The model you have pegged the rivets to is the one that sports the antenna "Whiskers". Is there a way to marry the rivets to the non rebecca model?
 
You must log in or register to reply here.
Back
Top