• There seems to be an uptick in Political comments in recent months. Those of us who are long time members of the site know that Political and Religious content has been banned for years. Nothing has changed. Please leave all political and religious comments out of the forums.

    If you recently joined the forums you were not presented with this restriction in the terms of service. This was due to a conversion error when we went from vBulletin to Xenforo. We have updated our terms of service to reflect these corrections.

    Please note any post refering to a politician will be considered political even if it is intended to be humor. Our experience is these topics have a way of dividing the forums and causing deep resentment among members. It is a poison to the community. We appreciate compliance with the rules.

    The Staff of SOH

  • Server side Maintenance is done. We still have an update to the forum software to run but that one will have to wait for a better time.

Control Settings will not save.....

Navy Chief

Navy Chief

Senior Member
I finally got Update 1.4 installed, and P3D is running, BUT.......always a but, it seems; my Saitek X52 settings aren't working and they will not save.

I use CH Rudder pedals too.

Seems like the settings are easier to make in FSX. Menu is similar, but P3D doesn't save what I am setting to my controls.

Any assistance here? If anyone has had similar difficulties, I would appreciate a link to the thread.

My system will be down for a while until I get my replacement RAM from G.Skill.

Thanks. NC

Update: I downloaded newest driver for Saitek controllers. Problems seem to be only in P3D. Elevator control not responding at all, but does in FSX. Have tried fixing in FSUIPC, but not working. It shows up in FSUIPC, but not working in game. NC
 
I had a similar problem with the CH Eclipse yoke and posted this same problem and it was suggested that if you still have FSX installed then use that to setup the controls and then copy the Controls folder from FSX into P3D. Seems to be working ok for me now.
 
AussieMan said:
I had a similar problem with the CH Eclipse yoke and posted this same problem and it was suggested that if you still have FSX installed then use that to setup the controls and then copy the Controls folder from FSX into P3D. Seems to be working ok for me now.
Click to expand...

Thanks!

NC
 
You must log in or register to reply here.
Back
Top