• There seems to be an uptick in Political comments in recent months. Those of us who are long time members of the site know that Political and Religious content has been banned for years. Nothing has changed. Please leave all political and religious comments out of the forums.

    If you recently joined the forums you were not presented with this restriction in the terms of service. This was due to a conversion error when we went from vBulletin to Xenforo. We have updated our terms of service to reflect these corrections.

    Please note any post refering to a politician will be considered political even if it is intended to be humor. Our experience is these topics have a way of dividing the forums and causing deep resentment among members. It is a poison to the community. We appreciate compliance with the rules.

    The Staff of SOH

  • Server side Maintenance is done. We still have an update to the forum software to run but that one will have to wait for a better time.

Final Object Flow Released from ORBX

Just to round this up:

The update also goes along with a new FTX Central version "FTX Central v3.2.3.0" and contains various V4 specific updates.



Cheers,
Mark
 
Finally! :redfire:
I’ll back to my FTX airports! Didnt install beta before so it was big break, near 5 months from June!
Great!
 
+1 to YoYo, +1 to Sue ... at least it made it in time for winter in Minnesota (when I do most of my sim flying).

Not to hijack the thread, but I will be looking to do some formation with some folks. Any recommendations from the assemblage as to how it works with P3D v4 and who is doing it? Thanks.
 
"Any recommendations from the assemblage as to how it works with P3D v4 and who is doing it?"
Jay, I would start another thread with that question. No one is going to see it in an OrbX object flow thread.
LOL
Sue
 
I installed the beta last week. I don't recall seeing the final install but it must have done when opening and closing FTX Central (fixing annoying elevation issues) and it says now v 3.2.3.0 and the box is checked saying "use ObjectFlow 2 in Prep 3D v4"

Would others agree or do am I missing another necessary step (e.g. downloading the whole - final - shabang again . . )?
 
expat, your description of how they upgraded to v3.2.3.0 is exactly the way things went for me. The upgrade uses Object Flow v2 if you check the settings. Usually I see an upgrade notice on the left side but didn't seem to happen this time. :untroubled:
 
My FTX Central updated in a similar fashion as expat's. I have about 20 NA airports and downloaded them, ran the airport configuration tool and loaded P3D v4. I chose to do a quick flight out of Redding, CA and ,oh boy, looking very nice. Even taxiing around the airport was interesting (remember...P3D is not for fun).
 
You must log in or register to reply here.
Back
Top