• There seems to be an up tick in Political commentary in recent months. Those of us who are long time members of the site we know that Political and Religious content has been banned for years. Nothing has changed. Please leave all political and religiours commentary out of the fourms.

    If you recently joined the forums you were not presented with this restriction in the terms of service. This was due to a conversion error when we went from vBulletin to Xenforo. We have updated our terms of service to reflect these corrections.

    Please note any post refering to a politicion will be considered political even if it is intended to be humor. Our experience is these topics have a way of dividing the forums and causing deep resentment amoung members. It is a poison to the community. We apprciate compliance with the rules.

    The Staff of SOH

  • Server side Maintenance is done. We still have an update to the forum software to run but that one will have to wait for a better time.

FS9 Henschel Hs 123 2D panel.zip

michaelvader

michaelvader

Members +
742016163304042308.jpg

A new entry has been added to Add-Ons Library, category FS 2004 Panels

Description: FS2004 ACOF FS9 Henschel Hs 123 panel

This zip contains a new 2D panel for the Henschel Hs 123 (henschel_hs123.zip) the VC has been adapted to the 2D panel as far as I could and also there is an alternative aircraft.cfg file.

By: Michael "Papi" Vader

To check it out, rate it or add comments, visit FS9 Henschel Hs 123 2D panel.zip
The comments you make there will appear in the posts below.
 
Nice work!
:ernaehrung004:

Is this meant for Scrubby's model or Chris Herring's? Or should it work for either one?

(I know the 2D would work for either model, but maybe not the VC?)
 
Hi Mick,
I used Scrubbies FS9/FSX Hs 123 as base.
If you use this model also the VC will fit even it is very summary.
Also the joined aircraft.cfg is done for Scrubbies model.
Now when you fly at 1000meters altitude with 1.0 ata manifold pressure,
you obtain about 285 km/h of speed and the trim is neutral.
As it should be
Yours
Papi
 
michaelvader said:
Hi Mick,
I used Scrubbies FS9/FSX Hs 123 as base.
If you use this model also the VC will fit even it is very summary.
Also the joined aircraft.cfg is done for Scrubbies model.
Now when you fly at 1000meters altitude with 1.0 ata manifold pressure,
you obtain about 285 km/h of speed and the trim is neutral.
As it should be
Yours
Papi
Click to expand...

Thanks Papi,

I have that model and I'll try your panel. It looks great in the screen shot and I'm sure it will look great in the sim.
 
Good evening friends,
just a little advice,
to make the whole thing a bit nicer I use the sound from Nigel Richards fine Avro Tutor
They fit perfectly to this plane
Yours
Papi
 
You must log in or register to reply here.
Back
Top