• There seems to be an uptick in Political comments in recent months. Those of us who are long time members of the site know that Political and Religious content has been banned for years. Nothing has changed. Please leave all political and religious comments out of the forums.

    If you recently joined the forums you were not presented with this restriction in the terms of service. This was due to a conversion error when we went from vBulletin to Xenforo. We have updated our terms of service to reflect these corrections.

    Please note any post refering to a politician will be considered political even if it is intended to be humor. Our experience is these topics have a way of dividing the forums and causing deep resentment among members. It is a poison to the community. We appreciate compliance with the rules.

    The Staff of SOH

  • Server side Maintenance is done. We still have an update to the forum software to run but that one will have to wait for a better time.

Mitsubishi F-2A/B P3Dv4.zip

K

kbt

Charter Member
652515214724398506.jpg

A new entry has been added to Add-Ons Library, category Prepar 3D / P4D Add-Ons

Description: This model has been created to conform to P3Dv4.

For P3D we have not tested with V1 V2 V3. As for P3D use, there are also sides that we have not yet managed to grasp P3D.

Please note that it may not be the best model.

Current VC is F-2A and F-2B are both single-seat VC. In short, F-2A's VC is used for F-2B.

Also, we can not do engine start operation at VC. Please use Ctrl + E to start the engine.

To check it out, rate it or add comments, visit Mitsubishi F-2A/B P3Dv4.zip
The comments you make there will appear in the posts below.
 
F-2A Fix V1.3 (Specular Fix)

The spec file file name is incorrect. With this fix, f-2a is displayed normally.
Place the enclosed file in the same place. (It will not be overwritten.)
Or change "f2_01_t_spec.dds" by appending "T" to the filename "f2_01_spec.dds". Please change 6 files from "f2_01_spec.dds" to "f2_06_spec.dds".


No effect on F - 2B.

https://drive.google.com/open?id=11S02tdujdUTti77h6TPrWeD1TrneKzeN

attachment.php
attachment.php
 

Attachments

  • fix_v13_f2_before.jpg
    fix_v13_f2_before.jpg
    49.6 KB · Views: 6
  • fix_v13_f2_after.jpg
    fix_v13_f2_after.jpg
    53.3 KB · Views: 6
Last edited:
F-2A/B Installed

Hi KTB!,

I sent one message to you but I don't think it "sent".

She looks stunning (exterior) and the interior looks pretty good too! It's nice to have an F-16 look alike that actually has weapons in P3D!

I downloaded and installed the F-2A/B into my P3D v4.2 sim without any apparent Issues. I did a flight from Edwards AFB to KSFO ( OVER AN HOUR FLIGHT). It went well, but I had to explore buttons and switches for the entire flight. Most aren't working. I finally found the Avionics switch and got Autopilot going, then set my altitude. I didn't see a manual.

In summary, this is fantastic AC with great potential. I'd consider buying it once it has been fully developed and refined.

Would you consider contacting me when updates are available? BTW, I noticed ladders and a drag chute in some of the photo's. Is there a shift command for activation. I didn't see one.

Kind Regards, and the best of luck to you,

Eagle (Col. Scott Gordon Mitchell USMC)
 
Engine runing

I'll add that the engine was running when I entered the "office". Would prefer "cold/dark". I wasn't sure about shutdown procedure. I did read that there is a ctrl+e startup.
 
You must log in or register to reply here.
Back
Top