• There seems to be an uptick in Political comments in recent months. Those of us who are long time members of the site know that Political and Religious content has been banned for years. Nothing has changed. Please leave all political and religious comments out of the forums.

    If you recently joined the forums you were not presented with this restriction in the terms of service. This was due to a conversion error when we went from vBulletin to Xenforo. We have updated our terms of service to reflect these corrections.

    Please note any post refering to a politician will be considered political even if it is intended to be humor. Our experience is these topics have a way of dividing the forums and causing deep resentment among members. It is a poison to the community. We appreciate compliance with the rules.

    The Staff of SOH

  • Server side Maintenance is done. We still have an update to the forum software to run but that one will have to wait for a better time.

Prepar3Dv3.2.exe

sidler

sidler

Charter Member
In the Event Viewer, I get Faulty Application name:prepar3d.exe, every time I load Simulator (Prepar3dv3.2). What does this mean?

Thanks
Dick
 
Dick, could you post the whole error message? There are important informations like the Event ID, faulting module, and so on.

Does P3D crash to desktop upon starting or does it run despite the entry in the event log?


Cheers,
Mark
 
Hi Mark

Here is the error message...
Faulting application name:prepar3D.exe
Event ID: 1000
Faulting application path:C:\Prepar3d v3\Prepar3d.exe

p.s. I installed the full Prepar3d v3.2, everything went fine until I installed A2A 182T Skyhawk, that is when I started getting that error message in the event viewer. I re-installed Prepar3d v3.2. Now everything seems to be working fine. I don't dare re-install A2A 182T! (this is A2A 182T for Prepar3d v3).

Dick
 
That event id usually points to an UAC access violation (file system permission) problem.

Did you invoke the A2A installer with "run as administrator"? I never had that error, so I can't tell from my own experience. You might want to post a thread in the A2A forum, there's usually a fast response to solve these problems!


Cheers,
Mark
 
Hi Mark

I'm waiting for an answer from A2A. I re-installed Prepar3D v3.2 and everything is working great but I have not A2A 182T yet. I might try to re-install with A2A 182T "run as administrator".

Thanks
Dick
 
Hi Mark

I re-installed Prepar3D v3.2, re-installed A2A 182T (ran as administrator) and everything seems fine now. I'm not getting that error anymore.


Dick
 
You must log in or register to reply here.
Back
Top