• There seems to be an uptick in Political comments in recent months. Those of us who are long time members of the site know that Political and Religious content has been banned for years. Nothing has changed. Please leave all political and religious comments out of the forums.

    If you recently joined the forums you were not presented with this restriction in the terms of service. This was due to a conversion error when we went from vBulletin to Xenforo. We have updated our terms of service to reflect these corrections.

    Please note any post refering to a politician will be considered political even if it is intended to be humor. Our experience is these topics have a way of dividing the forums and causing deep resentment among members. It is a poison to the community. We appreciate compliance with the rules.

    The Staff of SOH

  • Server side Maintenance is done. We still have an update to the forum software to run but that one will have to wait for a better time.

RealAir Scout DME question... where is it?

cavaricooper

cavaricooper

SOH-CM-2023
I have read the manual and scoured the aircraft- no joy. There is reference to a DME being available, and there is a DME speaker button on the ACP... but try as I might, I cannot locate a DME readout in the RealAir Scout. When scudrunning in the PNW it sometimes is very useful to have a radial and DME for positional information, and I would appreciate any pointer that would locate this for me... with Dimus' Locher on the horizon I have been practicing short field and obstructed approaches in this aeroplane, and the lack of a DME is my sole negative. After all these years, it's still a superlative airplane in Prepar3D v4.


Ta!

C
 
Although you can configure the avionics in the Realair American Champion aircraft, I'm almost certain there is no DME, so not sure where you would have seen reference to it.
 
Several of the a/c have an HSI option, and the Audio Control Panel includes a DME speaker selector button.... I "assumed" that it would accompany a DME (I know what they say about assuming...).

Best- C
 
I may be wrong, and I don't have the aircraft installed at present so I can't check, but I don't think the panel configurator works in P3d. This might be why you can't use the DME.
 
You must log in or register to reply here.
Back
Top