• There seems to be an up tick in Political comments in recent months. Those of us who are long time members of the site know that Political and Religious content has been banned for years. Nothing has changed. Please leave all political and religious comments out of the forums.

    If you recently joined the forums you were not presented with this restriction in the terms of service. This was due to a conversion error when we went from vBulletin to Xenforo. We have updated our terms of service to reflect these corrections.

    Please note any post refering to a politician will be considered political even if it is intended to be humor. Our experience is these topics have a way of dividing the forums and causing deep resentment among members. It is a poison to the community. We appreciate compliance with the rules.

    The Staff of SOH

  • Server side Maintenance is done. We still have an update to the forum software to run but that one will have to wait for a better time.

SPAD Interface for SAITEK controllers / P3D

roger-wilco-66

roger-wilco-66

Administrator
Staff member
Anyone using the SPAD interface for Saitek controllers in P3D ?
It is supposed to solve some problems with panels and the trim wheel, among others.

The developer of SPAD is very active and takes feature requests (see SPAD Forum), which should be supported IMO.

Here's the link:

http://fstools.weebly.com/index.html


Cheers,
Mark
 
I have been SPAD with the Saitek Radio and BIP panels for over a year. It works flawlessly for me.

When doing research about purchasing the Saitek panels, decided to not use the Saitek drivers at all. Have used SPAD since day one.
 
Yea, SPAD working for me thru FSX, P3Dv1.4, P3Dv2.0, P3Dv2.1, and I presume will through the Hotfix.

Only thing is the trimwheel. I have it assigned through FSUIPC but still seems to to be re-selected FSUIPC for it to work. I will start an aircraft, nothin'. Go into FSUIPC give the wheel a few spins, then back into P3D and then it works. That's the only device I have to perform this.
 
You must log in or register to reply here.
Back
Top