• There seems to be an uptick in Political comments in recent months. Those of us who are long time members of the site know that Political and Religious content has been banned for years. Nothing has changed. Please leave all political and religious comments out of the forums.

    If you recently joined the forums you were not presented with this restriction in the terms of service. This was due to a conversion error when we went from vBulletin to Xenforo. We have updated our terms of service to reflect these corrections.

    Please note any post refering to a politician will be considered political even if it is intended to be humor. Our experience is these topics have a way of dividing the forums and causing deep resentment among members. It is a poison to the community. We appreciate compliance with the rules.

    The Staff of SOH

  • Server side Maintenance is done. We still have an update to the forum software to run but that one will have to wait for a better time.

Spad.next and Flying Iron Hellcat

J

jmfabio

Charter Member
Hi all,

I need some help with programming button or axis to the Fuel selector valve. I know what the Lvar is and I know how to program buttons and axes but I can get the selector to move but not to stay. I know in the Lvar there are five positions but can't figure out the combination of settings in the event to make it work.

Can anyone help? It would be much appreciated. Thaks, Joe
 
Sorry for the late input, Joe. I have SPAD.Next but quit using it because it was too complicated for this old man. I use FSUIPC and Axis & Ohs. SPAD.Next has a Discord site that is very active. I am sure you will get more help over there.
 
John, Thanks for the reply. Perhaps I will try their discord site. I have only ever used regular forums and am not familiar with discord. I have managed to program Spad.next for the DC-3 fuel selector valves and when i get back to my sim computer, I will try the same approach with the F6F.

Thanks again,

Joe
 
You must log in or register to reply here.
Back
Top