I was reading the article over in the Newshawks Forum about the one found by fire fighters in Alaska in 1968. Great article. I found my old Stinson A made for FS9 by GAS and installed in FSX.SE to see if it would work. I had to change the prop textures only. Every thing works fine except there is a trans parent issue with the prop pitch and mixture levers missing knobs and a square hole in the panel that you can see thru. Anyone out there know how to fix this. It's a great little plane and flys great in FSX.
-
There seems to be an uptick in Political comments in recent months. Those of us who are long time members of the site know that Political and Religious content has been banned for years. Nothing has changed. Please leave all political and religious comments out of the forums.
If you recently joined the forums you were not presented with this restriction in the terms of service. This was due to a conversion error when we went from vBulletin to Xenforo. We have updated our terms of service to reflect these corrections.
Please note any post refering to a politician will be considered political even if it is intended to be humor. Our experience is these topics have a way of dividing the forums and causing deep resentment among members. It is a poison to the community. We appreciate compliance with the rules.
The Staff of SOH
Stinson Model A tri-motor in FSX
- Thread starter mcanx
- Start date
