• There seems to be an uptick in Political comments in recent months. Those of us who are long time members of the site know that Political and Religious content has been banned for years. Nothing has changed. Please leave all political and religious comments out of the forums.

    If you recently joined the forums you were not presented with this restriction in the terms of service. This was due to a conversion error when we went from vBulletin to Xenforo. We have updated our terms of service to reflect these corrections.

    Please note any post refering to a politician will be considered political even if it is intended to be humor. Our experience is these topics have a way of dividing the forums and causing deep resentment among members. It is a poison to the community. We appreciate compliance with the rules.

    The Staff of SOH

  • Server side Maintenance is done. We still have an update to the forum software to run but that one will have to wait for a better time.

UI turns white when I want to select vertices...

Hauksbee

Hauksbee

Members +
I found it necessary to do a re-install of Gmax. On the whole, it went well. But, when I hold down the LB and try to drag a selection box around a group of vertices, the area inside the four-view panels (and/or, the single full-screen panel) goes completely white. Everything disappears, model, vertices, everything until I release the mouse button. It is, of course, impossible to carefully select points if they disappear. Has anyone else ever had this problem? Is there a cure? I did not have this problem with the initial install. But the second, and even the third, I did.
 
Change your video driver in Gmax (Customize/Preferences, Viewports tab). When using XP (years ago) I used OpenGL but I have exactly that problem if I use OpenGL in Windows 7 with my graphics card. Direct3D works fine, though. Your mileage may vary!
 
You must log in or register to reply here.
Back
Top