• There seems to be an uptick in Political comments in recent months. Those of us who are long time members of the site know that Political and Religious content has been banned for years. Nothing has changed. Please leave all political and religious comments out of the forums.

    If you recently joined the forums you were not presented with this restriction in the terms of service. This was due to a conversion error when we went from vBulletin to Xenforo. We have updated our terms of service to reflect these corrections.

    Please note any post refering to a politician will be considered political even if it is intended to be humor. Our experience is these topics have a way of dividing the forums and causing deep resentment among members. It is a poison to the community. We appreciate compliance with the rules.

    The Staff of SOH

  • Server side Maintenance is done. We still have an update to the forum software to run but that one will have to wait for a better time.

Spad.Next Anyone here adept at using it?

Navy Chief

Navy Chief

Senior Member
I only just recently bought Spad.Next because I finally bought all of the Saitek Panels: Multi, Switch, Radio, and three (3) Annunciator panels. One question I have is can a profile be created to work with any/all aircraft that would work? I.e a global profile? This software seems quite complicated to use, and a little intimidating to me! NC
 
I use it, yep I have one global profile for aircraft with simply settings (used MSFS or P3D codes) but dedicated profile if the model use LVAR functions (on many important switches) like A2A, MiLviz ect.
 
YoYo said:
I use it, yep I have one global profile for aircraft with simply settings (used MSFS or P3D codes) but dedicated profile if the model use LVAR functions (on many important switches) like A2A, MiLviz ect.
Click to expand...

What panel or panels do you have, YoYo? And would you share the global profile(s)? I am really trying to get a grasp of how this works. NC
 
Navy Chief said:
What panel or panels do you have, YoYo? And would you share the global profile(s)? I am really trying to get a grasp of how this works. NC
Click to expand...

I have all panels and 5 FiPs, but now I don't use much because I fly differently.
Here you have my example for MSFS:

C:\Users\name\Documents\SPAD.neXt\profiles, I see that I have now .. 65 profiles (but mostly for P3D). Now I use VR during the flight, so many function I removed however You can check 1 ENG profile. I also divide the profiles into those with retractable landing gear or not, just the LEDs would not light up. Here axamples, if You need more, write me.

https://www.sendspace.com/file/95nxpj
 
YoYo said:
I have all panels and 5 FiPs, but now I don't use much because I fly differently.
Here you have my example for MSFS:

C:\Users\name\Documents\SPAD.neXt\profiles, I see that I have now .. 65 profiles (but mostly for P3D). Now I use VR during the flight, so many function I removed however You can check 1 ENG profile. I also divide the profiles into those with retractable landing gear or not, just the LEDs would not light up. Here axamples, if You need more, write me.

https://www.sendspace.com/file/95nxpj
Click to expand...

YOYO, I have not had much success, getting any off those profiles to work. They installed and activate ok, but not working with my panels. Maybe if I tried a few of P3D ones? NC
 
NC, did you uninstall all Saitek drivers before install the Spad? Next you must install „Spad bridge” (connector).
 
You must log in or register to reply here.
Back
Top