• There seems to be an uptick in Political comments in recent months. Those of us who are long time members of the site know that Political and Religious content has been banned for years. Nothing has changed. Please leave all political and religious comments out of the forums.

    If you recently joined the forums you were not presented with this restriction in the terms of service. This was due to a conversion error when we went from vBulletin to Xenforo. We have updated our terms of service to reflect these corrections.

    Please note any post refering to a politician will be considered political even if it is intended to be humor. Our experience is these topics have a way of dividing the forums and causing deep resentment among members. It is a poison to the community. We appreciate compliance with the rules.

    The Staff of SOH

  • Server side Maintenance is done. We still have an update to the forum software to run but that one will have to wait for a better time.

737 Max 8 engine reverse thrust

tiger1962

tiger1962

SOH-CM-2025
After trying all the "engine reverse" axis commands with my Logitech Flight Yoke System's throttle quadrant and getting nothing, I've finally found one that works:

"Previous detent".

I think the "engine reverse" and "reverse thrust" commands must be 'legacy' or 'deprecated' for FS24 - if that's the case then they should remove them altogether.
 
I'm using HOLD THROTTLE REVERSE THRUST with my Bravo throttle quadrant - the reverse thrust lever activates reverse and then moving the throttle lever forward increases the amount of thrust.
 
How strange! "Hold Throttle Reverse Thrust" used to work for me in all jets which had it in FS20, but not with the 737 in FS24 - it must be a 737 quirk then.
 
The smart adz comment would be that MSFS doesn't support 8 engines. Let us know all the solutions you find! Thanks
 
You must log in or register to reply here.
Back
Top