• There seems to be an uptick in Political comments in recent months. Those of us who are long time members of the site know that Political and Religious content has been banned for years. Nothing has changed. Please leave all political and religious comments out of the forums.

    If you recently joined the forums you were not presented with this restriction in the terms of service. This was due to a conversion error when we went from vBulletin to Xenforo. We have updated our terms of service to reflect these corrections.

    Please note any post refering to a politician will be considered political even if it is intended to be humor. Our experience is these topics have a way of dividing the forums and causing deep resentment among members. It is a poison to the community. We appreciate compliance with the rules.

    The Staff of SOH

  • Server side Maintenance is done. We still have an update to the forum software to run but that one will have to wait for a better time.

AC500S Bob Hoover prop control lever

F

Fredem

Members +
As Robert A. Hoover pass this morning, I wanted to fly its AC500 for my personnal tribute to this great pilot.

So, as I fly only in VC, I noticed that in pulling the propeller control 1, the propellor control 2 moved also, but only the prop 1 feathered. Same problem with the mixture control.

To feather the prop 2, I have to do it by the 2D panel and when flying aerobatics, it is not easy...

341137AC500SHoover.jpg


My AC500 is out of date ? There is a patch or an update somewhere ? I have to download another version ?
 
Rob Hoover has passed!?! How sad, I read his book "Forever Flying" a few years ago and was enthralled by it. I might have another read of it in his honour, may he R.I.P.

Taff
 
Fredem said:
As Robert A. Hoover pass this morning, I wanted to fly its AC500 for my personnal tribute to this great pilot.

So, as I fly only in VC, I noticed that in pulling the propeller control 1, the propellor control 2 moved also, but only the prop 1 feathered. Same problem with the mixture control.

To feather the prop 2, I have to do it by the 2D panel and when flying aerobatics, it is not easy...

My AC500 is out of date ? There is a patch or an update somewhere ? I have to download another version ?
Click to expand...

Sir, this model was done by Paul Saunders back in 2004 who was on my team for this project only. I do not have his gmax source to this model so I cannot address the issue.

My apologies.
 
Milton Shupe said:
Sir, this model was done by Paul Saunders back in 2004 who was on my team for this project only. I do not have his gmax source to this model so I cannot address the issue.

My apologies.
Click to expand...

Thanks for the answer, Milton !

what a pity this can be corrected !


Yes, Bob is now missing ! But, when I think about his life, dying as a very old man is also an achievement !
 
"There are old pilots, and there are bold pilots, but there are no old bold pilots."

Well, except for Bob Hoover...
 
Would Rob Barendregts 'Selection Correction' gauge not fix this (at Avsim), or FSUIPC advanced settings; just a thought.

ttfn

Pete
 
I doubt it. If the 2D works correctly, then you're looking at a problem with animation assignments in the 3D code. Without the original source, you're stuck.
 
You must log in or register to reply here.
Back
Top