• There seems to be an uptick in Political comments in recent months. Those of us who are long time members of the site know that Political and Religious content has been banned for years. Nothing has changed. Please leave all political and religious comments out of the forums.

    If you recently joined the forums you were not presented with this restriction in the terms of service. This was due to a conversion error when we went from vBulletin to Xenforo. We have updated our terms of service to reflect these corrections.

    Please note any post refering to a politician will be considered political even if it is intended to be humor. Our experience is these topics have a way of dividing the forums and causing deep resentment among members. It is a poison to the community. We appreciate compliance with the rules.

    The Staff of SOH

  • Server side Maintenance is done. We still have an update to the forum software to run but that one will have to wait for a better time.

Aerosoft F-14 Extended Released

Trim issues?

I'm running this in P3D V3, but figured this side gets more traffic.

I reinstalled the Tomcat X and started up on the runway at Fallon. Just wanted to test it out after a long time away.

Anyhow, I noticed I couldnt trim off the nose up attitude of the jet. Flaps were up, wings out, but it still wanted to climb. Swept the wings and same results. Did I miss a switch?

Also, is there a low-viz VF-1 Wolfpack repaint anywhere?

-Jeff
 
Prior to takeoff are your trim gauges by your virtual left knee zeroed out?

For VF1 low vis, maybe a request over at Groom Lake sims on facebook
 
Victory103 said:
Prior to takeoff are your trim gauges by your virtual left knee zeroed out?

For VF1 low vis, maybe a request over at Groom Lake sims on facebook
Click to expand...

Thank you. I'll check that gauge to see. Probably missed that.

And rgr on the FB page. Thanks again.

-Jeff
 
ST0RM said:
I'm running this in P3D V3, but figured this side gets more traffic.

I reinstalled the Tomcat X and started up on the runway at Fallon. Just wanted to test it out after a long time away.

Anyhow, I noticed I couldnt trim off the nose up attitude of the jet. Flaps were up, wings out, but it still wanted to climb. Swept the wings and same results. Did I miss a switch?

Also, is there a low-viz VF-1 Wolfpack repaint anywhere?

-Jeff
Click to expand...

This climb attitude is normal, as the developers stated on the AS forum.
 
You must log in or register to reply here.
Back
Top