• There seems to be an up tick in Political commentary in recent months. Those of us who are long time members of the site we know that Political and Religious content has been banned for years. Nothing has changed. Please leave all political and religiours commentary out of the fourms.

    If you recently joined the forums you were not presented with this restriction in the terms of service. This was due to a conversion error when we went from vBulletin to Xenforo. We have updated our terms of service to reflect these corrections.

    Please note any post refering to a politicion will be considered political even if it is intended to be humor. Our experience is these topics have a way of dividing the forums and causing deep resentment amoung members. It is a poison to the community. We apprciate compliance with the rules.

    The Staff of SOH

  • Server side Maintenance is done. We still have an update to the forum software to run but that one will have to wait for a better time.

FS2004 Oil Cooler Shutter

michaelvader

michaelvader

Members +
Hallo Huub,
hallo the experts,
does any one how to make, or if it exists a switch or lever
to command the oil cooler flaps of the WWII Fighters Messerschmitt Bf109E
on a 2D panel?
The "normal" cowl flaps are not a problem.
But the oil cooler flap on this bird operates only by a virtual lever in the VC.
I want also operate this flap via the 2D panel
Yours
Papi
 
Papi,

I thought I would be able to find an .xml file which controlled this lever in the .cab file and function in the panel configuration file. But there wasn't there, so I will have to look further.

Kind regards.
Huub
 
Hallo Huub,

thank you to have a look on to this problem.
I also searched if somewhere in the used gauged this function would be hidden.
I also searched all over FS if this function exist - nothing.
So I supose this function would be hidden in the mdl - but if it would be possible to extract this special function, would it be possible to "translate" it into a functional switch operational in FS2004?
I observed that this function has an paralell function in the trop model - it closes the air intake of the sand filter.
Perhaps it might give some indications
Yours
Papi
 
You must log in or register to reply here.
Back
Top