• There seems to be an up tick in Political comments in recent months. Those of us who are long time members of the site know that Political and Religious content has been banned for years. Nothing has changed. Please leave all political and religious comments out of the forums.

    If you recently joined the forums you were not presented with this restriction in the terms of service. This was due to a conversion error when we went from vBulletin to Xenforo. We have updated our terms of service to reflect these corrections.

    Please note any post refering to a politician will be considered political even if it is intended to be humor. Our experience is these topics have a way of dividing the forums and causing deep resentment among members. It is a poison to the community. We appreciate compliance with the rules.

    The Staff of SOH

  • Server side Maintenance is done. We still have an update to the forum software to run but that one will have to wait for a better time.

Heading / track error Jahn Basler and C-47

A

aspen31

Members +
HSI Heading / course errors Jahn Basler and C-47

Hi all
I have been flying both the Jahn Basler BT-67 and C-47 in Prepar3d. Up until the last few days they have been operating almost flawlessly in the Prepar3d environment. I have been flying around the Bahamas using addon scenery designed for FSX but which seems to work well in Prepar3d. Lately I have noticed that the HSI and GPS track information is in consistent error of about 120 degrees. The compass in each airplane reads correctly. I did not notice a problem previously operating in the same area using the same scenery. Years ago I experienced a similar problem in FS2004 and it was related to a scenery package which I could only resolve by removing that particular scenery. Just wondering if anyone has experienced a similar problem in Prepar3d and if a solution might have been found.
Thanks
Warren
 
Last edited:
Hi again
I am slightly in error. Only the HSI course and heading information are in error. The GPS track info is correct.
Thanks
Warren
 
You must log in or register to reply here.
Back
Top