• There seems to be an up tick in Political commentary in recent months. Those of us who are long time members of the site we know that Political and Religious content has been banned for years. Nothing has changed. Please leave all political and religiours commentary out of the fourms.

    If you recently joined the forums you were not presented with this restriction in the terms of service. This was due to a conversion error when we went from vBulletin to Xenforo. We have updated our terms of service to reflect these corrections.

    Please note any post refering to a politicion will be considered political even if it is intended to be humor. Our experience is these topics have a way of dividing the forums and causing deep resentment amoung members. It is a poison to the community. We apprciate compliance with the rules.

    The Staff of SOH

  • Server side Maintenance is done. We still have an update to the forum software to run but that one will have to wait for a better time.

landing lights I woud like to add landing lights for the DSB Typhoon Eurofighter

P

PhantomP

Charter Member
landing lights I woud like to add landing lights for the DSB Typhoon Eurofighter

Hey all I would like to add some landing lights for the DSB typhoon how hard is it and is there any downloads for this aircraft that you can use to add landing lights also would like a different panel any suggestions Thanks:d
 
Phantom,

if you mean the cone of light on the ground, it already has it, make sure you point your lights down a bit if need be. (shift+ctrl+Num2 (make sure num lock is off)). There is also a glow effect included.

Jamie
 
If you mean A2A 3D lights, well I knocked this together if it helps? Strangely there is only one light modelled on the gear door, but the cfg calls for 2 glow points near each main gear. Also the 3D lights cfg I have saved for the alphasim version shows two lights aswell, if I had it I would check. So I stuck in two :d I also added a VC light (I know it doesn't have one, but it looks nice from spot view :d)

You don't need the gauge, as there is already a gauge installed for them.

[lights]
light.0 = 2, -4.8, 0, 2.8, fx_shockwave_beacon // Shockwave light
light.1 = 2, 9.1, 2.4, -2.4, fx_shockwave_strobe // Shockwave light
light.2 = 3, -11, 17.8, -1, fx_shockwave_navgre // Shockwave light
light.3 = 3, -11, -17.5, -1, fx_shockwave_navred // Shockwave light
light.4 = 5, -3, -6, -3.5, efall
light.5 = 5, -3, 6, -3.5, efall
light.6 = 6, -20, 1.7, 3.1, fx_efaburner
light.7 = 6, -20, 1.7, 3.1, fx_efaburner
light.8 = 6, -20, -1.7, 3.1, fx_efaburner
light.9 = 6, -20, -1.7, 3.1, fx_efaburner
light.10 = 5, -3, -6.5, -3.2, fx_shockwave_landing_light_small_xenon // Shockwave light
light.11 = 5, -3, 6.5, -3.2, fx_shockwave_landing_light_small_xenon // Shockwave light
light.12 = 4, 14.8, 0, 2.5, fx_shockwave_vclight // Shockwave light
Click to expand...

Jamie
 
Hey JDTinballs Seems like the cone on the DSB Typhoon is a little off when starting fs9 is there a way to fix this thanks for help
 
You must log in or register to reply here.
Back
Top