• There seems to be an up tick in Political commentary in recent months. Those of us who are long time members of the site we know that Political and Religious content has been banned for years. Nothing has changed. Please leave all political and religiours commentary out of the fourms.

    If you recently joined the forums you were not presented with this restriction in the terms of service. This was due to a conversion error when we went from vBulletin to Xenforo. We have updated our terms of service to reflect these corrections.

    Please note any post refering to a politicion will be considered political even if it is intended to be humor. Our experience is these topics have a way of dividing the forums and causing deep resentment amoung members. It is a poison to the community. We apprciate compliance with the rules.

    The Staff of SOH

  • Server side Maintenance is done. We still have an update to the forum software to run but that one will have to wait for a better time.

MAIW Scenery trees!

J

jackryan172

SOH-CM-2025
Hi All,

I dont know if this has been asked before or not, I didnt find much help in searching the forums. I have trees! Lots of trees where there shouldnt be any. Like taxiways and ramps. And runways lots of runway trees. All the sceneries are MAIW ones, like Martinsburg, W VA. I tried putting an exclude and a flatted for both sceneries (main and LC) and they didnt work. I can get the trees to go away with an exclude, but that takes the runway with it. I have searched for conflicting BGLs but didnt find any. so Im stuck. Its ammusing to see C-5s with big trees going out of them but doesnt add much to the realism.

Thanks,
Sean
 
Sounds like the scenery maker had their autogen density set lower that yours. Try turning down your autogen scenery density and you should reach a level where those trees disappear.
 
so I finally got back to this problem, and I turned the autogen down and that made the trees disappear. Is that the only solution for this?

Sean
 
Yes, if you want to affect the 'world'. If it's an airport or other specific area, you can make an exclude for that area...which works with excluding buildings and airport infastructure, although I'm not sure if that affects default gen scenery like tress etc?

Cheers

Shessi
 
jackryan172 said:
so I finally got back to this problem, and I turned the autogen down and that made the trees disappear. Is that the only solution for this?

Sean
Click to expand...

Hey Sean, I’ve been having the same issue for a long time. I was thinking maybe it was the MAX VERTEX value in the FS9.CFG but now that I’ve read this, I understand it’s not that. So my question is, what is your new autogen value? I’d like to try your setting and see if it helps me as well. Thank you for bringing this to our attention. I was getting discouraged. Best regards, Jeremy
 
I ended up using the slider control to adjust the autogen. I didnt look at it but Im sure it was around 1 (based on TERRAIN_AUTOGEN_DENSITY=X. I think)

Sean
 
You must log in or register to reply here.
Back
Top