• There seems to be an uptick in Political comments in recent months. Those of us who are long time members of the site know that Political and Religious content has been banned for years. Nothing has changed. Please leave all political and religious comments out of the forums.

    If you recently joined the forums you were not presented with this restriction in the terms of service. This was due to a conversion error when we went from vBulletin to Xenforo. We have updated our terms of service to reflect these corrections.

    Please note any post refering to a politician will be considered political even if it is intended to be humor. Our experience is these topics have a way of dividing the forums and causing deep resentment among members. It is a poison to the community. We appreciate compliance with the rules.

    The Staff of SOH

  • Server side Maintenance is done. We still have an update to the forum software to run but that one will have to wait for a better time.

Need a little help !!

WND

WND

Charter Member
Good morning:

I've run across an issue with FSX-A whereby I cannot start up any 'Turbo Props' (stock aircraft or addon) whether I try from 'inside the cockpit' or using 'control E'..

They will 'spool up' but they won't 'ignite the fire' !!

Does anyone have any idea's what could be causing this 'glitch' ?? Sure would appreciate it..

Thanks;

Bill
 
WND said:
Good morning:

I've run across an issue with FSX-A whereby I cannot start up any 'Turbo Props' (stock aircraft or addon) whether I try from 'inside the cockpit' or using 'control E'..

They will 'spool up' but they won't 'ignite the fire' !!

Does anyone have any idea's what could be causing this 'glitch' ?? Sure would appreciate it..

Thanks;

Bill
Click to expand...

I assume you have the fuel lever (prop condition lever) set to ground idle, props full forward, pumps on, brakes locked, windshield washer full? :)
 
Milton Shupe said:
I assume you have the fuel lever (prop condition lever) set to ground idle, props full forward, pumps on, brakes locked, windshield washer full? :)
Click to expand...

That is correct !!! The windshield washer is full of fluid and the 'porta potties' are empty !!!

I will also state that it appears I have no issue's starting up 'piston' aircraft or 'pure' jets - it's just 'turbo props !!

Bill
 
Good advice Henry.

I always do that plus cntrl+F4, then cntrl+e

Bill, have you tried starting a gas engine aircraft then switch to a TP, then shutdown and restart?
 
Milton Shupe said:
Good advice Henry.

I always do that plus cntrl+F4, then cntrl+e

Bill, have you tried starting a gas engine aircraft then switch to a TP, then shutdown and restart?
Click to expand...

Nope !! I'll try all these and be back in a minute !!


EDIT: Well, so far so good.. Loaded up the Caravan, tried the 'control+shift+F4' and all that does and put the mixture at full rich, did a 'control E' start and all it would do was 'spool up' to 12% and stay there..

Then I started up a 'piston' aircraft, swapped over to the Caravan and then the King Air, all went well on both.. Then I swapped back to the Caravan - shut it down - and restarted it from the cockpit and all went well again..

So whatever it was that fixed it, I thank you !! Now we'll go try and see if I can get the CV580 running !!! LOL

Bill
 
Well, after some more experimenting, I've come to the conclusion that my Turbo Props just don't like starting from the 'cold / dark' setting !!!
 
WND said:
Well, after some more experimenting, I've come to the conclusion that my Turbo Props just don't like starting from the 'cold / dark' setting !!!
Click to expand...

What aircraft do you use for your default flight and is it all setup for cold and dark? Using the default Kingair as an example, I start out in my cold and dark condition, pull the condition levers down to fuel cutoff, turn on the battery, click the engine start for the left engine and let it spool up for about 6-8 seconds and then slowly move the left condition lever to low idle position and the engine engages. The I do the same for the right engine. I do the same procedure for all turbo props if I don't use Ctrl+E.
 
Turboprops will start cold and dark without issue, even the Caravan.

Things that will inhibit startup:
- No fuel
- Master fuel valve closed
- Fuel selector to off
- Lack of electrical power
 
I had the same shenanigans with Piglet’s OV-1 until I deleted the default flight and let FSX build a new one. All good after that.
 
I had the same shenanigans with Piglet’s OV-1 until I deleted the default flight and let FSX build a new one. All good after that.


Good morning HS:

Well, I deleted my 'default flight', created a new one and it made no difference - turbo props still will not start whether I use 'control E' or doing it from the cockpit !!

However, I can start a 'piston' aircraft and then swap over to a turbo prop and all appears to work ok.. So for now, I'll live with that - I usually don't fly turbo props - it just so happen I had one that I wanted too..

It's probably something simple and I'll figure it out someday !! LOL

Bill
 
ncooper said:
Hello,

the secret is not to create a new one but to load the default one.
Click to expand...
Quick, easy, way to do that is to open your FSX.cfg file with NotePad ONLY, find the heading [USERINTERFACE], and under that heading, find the line SITUATION=FLIGHTS\OTHER\FLTSIM. Delete anything and everything after the "=" sign, so it looks like SITUATION= . Save the file, close it, and start FSX. Now the default, Default flight is loaded. The Trike over Friday Harbour.
Remember to always make a backup of ANY file you want to edit, so if you mess up something badly, like I do all the time :adoration:, you can start all over again.

I've noticed that sometimes, if I don't end my flight at an airport, FSX:SE won't start unless I do that. Needless to say, though I will anyway, I've gotten pretty good at it :D
Have fun!
Pat☺
 
You must log in or register to reply here.
Back
Top