IanHenry
Charter Member
Title says it all really.
http://www.orbxsystems.com/forum/topic/138335-ftx-vector-available-for-p3dv4/
Ian
http://www.orbxsystems.com/forum/topic/138335-ftx-vector-available-for-p3dv4/
Ian
-
There seems to be an uptick in Political comments in recent months. Those of us who are long time members of the site know that Political and Religious content has been banned for years. Nothing has changed. Please leave all political and religious comments out of the forums.
If you recently joined the forums you were not presented with this restriction in the terms of service. This was due to a conversion error when we went from vBulletin to Xenforo. We have updated our terms of service to reflect these corrections.
Please note any post refering to a politician will be considered political even if it is intended to be humor. Our experience is these topics have a way of dividing the forums and causing deep resentment among members. It is a poison to the community. We appreciate compliance with the rules.
The Staff of SOH
Orbx Vector for V4 Released
- Thread starter IanHenry
- Start date
I agree Pat. Supposedly they have had access to V4 earlier than the mainstream user, still we are almost two months into the release of V4 and yet to see any 64bit ObjectFlow.
vora
Charter Member
To be fair, both ObjectFlow and Vector are third party software which they didn't have control of. Their in-house stuff (Central, Global, OpenLC, regions) were ready pretty much from the start.
Apparently they have now acquired the Vector code from Pilot's and are working on an in-house version of ObjectFlow ("OF2"). So next time we will see how fast or slow they really are.
Some facts:
The delay remains with the objectflow module which could not be developed until the RTM version of P3Dv4 was released.
It is easy to criticise when not knowing the facts and a little unfair to assume that this delay is due to some form of incompetence.
I can tell you that the revised objectflow is now in beta testing and that as soon as it is ready, those airports that require it will be released for P3Dv4.
Many airports would lack buildings without objectflow and I am sure that the torrent of abuse would be far greater if the products were released and didn't work.
I know the facts, but I can still see why their customers are getting impatient.
There is no FTX Central 4, the latest version is FTX Central 3.2 that is compatible with P3D v4. You can download and install from there. You also config from FTX Central as well. Check below the download and install area for the configuration link.