• There seems to be an uptick in Political comments in recent months. Those of us who are long time members of the site know that Political and Religious content has been banned for years. Nothing has changed. Please leave all political and religious comments out of the forums.

    If you recently joined the forums you were not presented with this restriction in the terms of service. This was due to a conversion error when we went from vBulletin to Xenforo. We have updated our terms of service to reflect these corrections.

    Please note any post refering to a politician will be considered political even if it is intended to be humor. Our experience is these topics have a way of dividing the forums and causing deep resentment among members. It is a poison to the community. We appreciate compliance with the rules.

    The Staff of SOH

  • Server side Maintenance is done. We still have an update to the forum software to run but that one will have to wait for a better time.

Prepar3D Version 1.4 Download

Bill , (and MM)

I just finished loading P3D and all went well , without errors . Just to clarify there are two times (according to installation instructions) to "Run As Administrator" . Right click on Setup.exe during initial installation and right click again on the Prepar3D.exe (inside Prepar3D folder). I believe instructions were specific that both(setup and Prepar3D.exe's) had to be "Ran As Administrator" or these type of errors would occur .


oooooooooooooooooo...... yep.. I remember this. When I was running my installer for Build 1.4, I realized I didnt start the Installer with 'run as Administrator and quickly killed the installation, deleted stuff, and restarted.

That my be why I have no issues.

MudMarine, did you run the 'installer' as Administrator? If not, uninstall and do that now.


Bill
 
Finally got it running! Don't ask me what I did........? All seems well after the 5th install, fingers crossed!
 
Well I have finally downloaded P3D V1.4 but have uninstalled it and gone back to V1.3 as the Australian stuff from ORBX won't port over as there is a problem with the Migrator Tool.

When that is sorted then I will reload V1.4.
 
Sorry about that Pat.

Was it running ok for you to begin with?

I hope they get the migrator tool working again for the new Build.




Bill
 
Bill P3D 1.4 worked great for me but when I ported over the ORBX stuff only the PNW stuff ported over. ORBX are aware of the problem and are working on a fix.
 
Back
Top