• There seems to be an uptick in Political comments in recent months. Those of us who are long time members of the site know that Political and Religious content has been banned for years. Nothing has changed. Please leave all political and religious comments out of the forums.

    If you recently joined the forums you were not presented with this restriction in the terms of service. This was due to a conversion error when we went from vBulletin to Xenforo. We have updated our terms of service to reflect these corrections.

    Please note any post refering to a politician will be considered political even if it is intended to be humor. Our experience is these topics have a way of dividing the forums and causing deep resentment among members. It is a poison to the community. We appreciate compliance with the rules.

    The Staff of SOH

  • Server side Maintenance is done. We still have an update to the forum software to run but that one will have to wait for a better time.

Problem with outside view on Manfreds new DC3.v3 and EZCA

ejoiner

ejoiner

Charter Member
Hi guys. I have a wierd problem with Mandreds new C47v3. Using Ezdok for both internal and external viewing, I have no problem at all in the cockpit using my created EZCA ecs file for viewing. However, when I go to the external view also using Ezdok, only the interior model of the C47 is shown. I get the cockpit box and two wings. No fuselage.

Using standard "S" view, I can see everything fine. Only when using Ezdok in external view do I have a problem. I dont have this issue with any of my other airplanes AND interestingly, I do not have this issue with Manfreds previous v2 C-47 using exactly the same ECS profile.

Anybody else with this issue or suggested cure?
 
Try running the EZDOK Config.exe, even if you have already run it. I noticed that the new release I had to run it twice, but I do get a good exterior set of cameras with this model.
 
You must log in or register to reply here.
Back
Top