• There seems to be an uptick in Political comments in recent months. Those of us who are long time members of the site know that Political and Religious content has been banned for years. Nothing has changed. Please leave all political and religious comments out of the forums.

    If you recently joined the forums you were not presented with this restriction in the terms of service. This was due to a conversion error when we went from vBulletin to Xenforo. We have updated our terms of service to reflect these corrections.

    Please note any post refering to a politician will be considered political even if it is intended to be humor. Our experience is these topics have a way of dividing the forums and causing deep resentment among members. It is a poison to the community. We appreciate compliance with the rules.

    The Staff of SOH

  • Server side Maintenance is done. We still have an update to the forum software to run but that one will have to wait for a better time.

REX Sky Force 3D / P3D (v5)

Sledge Hammer

Sledge Hammer

Members +
Hi everyone, :)

I need your help again.

I use the flight simulator Prepaid3D V5.3. I have no problems with it; it works without any issues.

I purchased the Rex Sky Forceprogramme (build number: 5.0.2022.0516) for P3D (V5.3) a long timeago. The purchase, download and installation went smoothly. I checkedthe manual to see if this software is compatible with P3D V 5. Themanual stated that the software is compatible with P3D V 5.

I installed the software asstandard and did not make any changes. I just checked that thesettings were correct. I also checked that the path to P3D was setcorrectly, which it was.

I wanted to change the sunlight inRex, so I proceeded as follows:

1 I saw the original sunlight inP3D.

2 Then I exited P3D.

3 Then I changed the sunlight inRex and installed the corresponding texture. (The installation wassuccessful).

4 Then I closed Rex.

5 Then I started P3D and checkedthe sunlight to see if the changes were successful.

6 Unfortunately, it didn't work. Istill saw the original sunlight as it was at the beginning.

I had the same problem with dawn,dusk and the daytime sky.

Unfortunately, support for REX hasalready expired, so I have to turn to you. Because I really want tocontinue using this software, I really hope that someone can help mewith this small problem. I would be very grateful if you could tellme what I need to do to make the Rex software work.


Thank you very much for your help.

Best regards,
Bruno :)
 
You must log in or register to reply here.
Back
Top