• There seems to be an uptick in Political comments in recent months. Those of us who are long time members of the site know that Political and Religious content has been banned for years. Nothing has changed. Please leave all political and religious comments out of the forums.

    If you recently joined the forums you were not presented with this restriction in the terms of service. This was due to a conversion error when we went from vBulletin to Xenforo. We have updated our terms of service to reflect these corrections.

    Please note any post refering to a politician will be considered political even if it is intended to be humor. Our experience is these topics have a way of dividing the forums and causing deep resentment among members. It is a poison to the community. We appreciate compliance with the rules.

    The Staff of SOH

  • Server side Maintenance is done. We still have an update to the forum software to run but that one will have to wait for a better time.

Rudder Pedal Assignment

Crusader

Crusader

SOH-CM-2022
Decided to reload CFS3 after a long absence . Deleted slider assignment under rudder pedals(CH PRO)due to throtlle being reversed . Now the throttle slider(CH Combat Stck)is operating throttle and not the rudder. Having difficulty assigning the rudders now to the pedals . I,ve saved a configuration for pedals but everytime I try to move the pedals to assign them it deaufts the assignment to the throttle slider . Sorry if this sounds confusing but I think I remember along time ago that there was a couple of lines I had to add to one of CFS3's config files or something to this effect . Any ideas on getting the rudders to works with the pedals and are toe brakes possible in CFS3 ? I think I found the solution to this a long time ago right here at the Out-House but due to the recent forum crash it wiped the thread out .

Any help appreciated ,

Rich
 
crusader the lines you may remember were for saitek pedals. are those the line your looking for?i don't know about the ch controls.
 
I've got the CH Pro pedals . I just have to find out how to add the Z axis that I assume are for the pedals . The only thing that shows up is the X and Y axis that I believe go with the Ailerons and elevator . I'll keep searching on the net and see if I can come with something .Thanks for the responses .
 
I have the CH stick, throttle and pedels. And in my CH manager the stick is X and Y axis, throttle is Z axis and pedels are R axis. In the CH manager it looks like it allows you to assign any axis to any controller. I haven't tried as the ones I listed were the default ones.
 
tenspeed said:
I have the CH stick, throttle and pedels. And in my CH manager the stick is X and Y axis, throttle is Z axis and pedels are R axis. In the CH manager it looks like it allows you to assign any axis to any controller. I haven't tried as the ones I listed were the default ones.
Click to expand...


Thanks tenspeed

I finally got enough nerve to load up CH manager as I have never used it before . I found a PDF file " CH Manager For Dummies" which certainly applies to me and gave it a try . I just mapped the CH Pro Pedals so far and you are right . You can assign any axis and it was fairly easy . Going to try the Combat Stick later .CFS3 shows its age I guess as I have FS9 and FSX and they automatically pick up everything .I've had CFS3 since it came out and thought I would reload on a new comp and give the "PTO" a try a blow up some things:costumes:


Thanks again ,
Rich:ernae:
 
You must log in or register to reply here.
Back
Top