• There seems to be an uptick in Political comments in recent months. Those of us who are long time members of the site know that Political and Religious content has been banned for years. Nothing has changed. Please leave all political and religious comments out of the forums.

    If you recently joined the forums you were not presented with this restriction in the terms of service. This was due to a conversion error when we went from vBulletin to Xenforo. We have updated our terms of service to reflect these corrections.

    Please note any post refering to a politician will be considered political even if it is intended to be humor. Our experience is these topics have a way of dividing the forums and causing deep resentment among members. It is a poison to the community. We appreciate compliance with the rules.

    The Staff of SOH

  • Server side Maintenance is done. We still have an update to the forum software to run but that one will have to wait for a better time.

Strange AI Behavior P3D v3.4

A

aspen31

Members +
Hi folks
This is a strange one and not something I have seen in all my years of simulation. I use a variety of AI aircraft in P3D including some from the great Cal Classic site and I have done so for quite some time. Recently I upgraded to V3.4 - the latest before V4 and since then have seen some AI behave in a very strange manner. On several occasions at least at 2 airports KMIA (addon) and KHST (modified by me) some aircraft fly all over the place climbing vertically and then diving into the ground only to rise again - in general behaving erratically - others function as they should. It seems this may come mostly from the CV-240s although I'm not positive. I'm wondering if anyone may have seen this in the past and might offer any (reasonable) suggestion. Overall it looks like a poorly run airshow and spoils the immersive experience to say the least.
Thanks in advance.
Warren
 
Have you check the AFCAD files to make sure none are FS9? Also, didn't the AI aircraft have to be upgraded to FSX in order to work properly? Are all you AI, FSX models?

Just two possible ideas.
 
Hi John
Most if not all of my traffic folders have been used in previous iterations of P3D without any problem as far as I know. I believe that all the AI aircraft and AFCADS are FSX compliant although it's always possible that something may have sneeked in through the back door. I'll try to watch and see if there is a particular culprit doing this and narrow it down. A good start.
Thanks
Warren
 
You must log in or register to reply here.
Back
Top